Highvalue biochemical merchandise applications of river eukaryotic microalgae

The maximum power of LCGD is 52 W. The limits of detection and precision (RSD, in 1 mg L-1) of K, Na, Ca, and Mg are 0.20, 0.02, 0.01, and 0.01 mg L-1 and 0.9, 1.5, 0.6, and 1.2%, respectively. The measurement results of K, Na, Ca, and Mg in water samples by LCGD-AES are basically in agreement with the reference values measured by IC. The recovery of samples ranged from 84 to 113% except for Na, suggesting that the measurement results have high accuracy and reliability. All the results indicated that the LCGD-AES can provide an alternative analytical method for in situ, real-time, on-line determination of K, Na, Ca, and Mg in water samples from rivers and lakes.The stator and rotor of an all-metal screw pump are made of metal; so the matching method of the all-metal screw pump cannot be like that of the traditional rubber screw pump, and a certain gap must be reserved. If the gap is too small, it will affect the normal operation of the pump. If the gap is too large, the pump leakage will also become larger, affecting the efficiency of the pump. In this paper, the method of numerical simulation is used to optimize the gap of the pump. At the same time, it is found that the optimal gap of the pump is closely related to the viscosity of the fluid transported by the pump, and different viscosity fluids have different optimal speeds. The speed and clearance of the pump are optimized through numerical simulation to ensure high pump efficiency while taking into account energy saving and avoid the waste caused by excessively high speed. Finally, the relevant research results of numerical simulation are verified through experiments, and it is found that the experimental results are in good agreement with the simulation results, which also proves the accuracy of the numerical simulation results.Hydroxylammonium nitrate (HAN) is a promising green propellant because of its low toxicity, high volumetric specific impulse, and reduced development cost. Electrolytic decomposition of HAN is an efficient approach to prepare it for further ignition and combustion. click here This paper describes the investigation of a co-electrolysis effect on electrolytic decomposition of HAN-fuel mixtures using stainless steel-platinum (SS-Pt) electrodes. For the first time, different materials were utilized as electrodes to alter the cathodic reaction, which eliminated the inhibition effect and achieved a repeatable and consistent electrolytic decomposition of HAN solution. Urea and methanol were added as fuel components in the HAN-fuel mixtures. When the mass ratio of added urea ≥20%, the electrolytic decomposition of a HAN-urea ternary mixture achieved 67% increment in maximum gas temperature (Tgmax) and 185% increment in overall temperature increasing rate over the benchmark case of HAN solution. The co-electrolysis of urea released additional electrons into the mixtures and enhanced the overall electrolytic decomposition of HAN. In contrast, the addition of methanol did not improve the Tgmax but only increased the overall temperature increasing rate. This work has important implications in the development of an efficient and reliable electrolytic decomposition system of HAN and its mixtures for propulsion applications.The strength of the photoluminescence excitation (PLE) spectrum of SrMgAl10O17Eu2+, Mn2+ (SAMEu2+, Mn2+) phosphor increased at deep blue (∼430 nm) and red-shifted from violet to deep blue with increasing concentrations of both Eu2+ ions Mn2+ ions. Eu2+-Mn2+ energy transfer between Eu2+ ions in Sr-O layer and Mn2+ ions at Al-O tetrahedral sites was maximized, and the photoluminescence (PL) intensity of the narrow-band Mn2+ emission was improved by optimizing the concentrations of Eu2+ and Mn2+ ions. The PL emission spectrum of the (Sr0.6Eu0.4)(Mg0.4Mn0.6)Al10O17 (SAMEu2+, Mn2+) phosphor peaks was optimized at 518 nm at a full width at half-maximum (FWHM) of 26 nm under light-emitting diode (LED) excitation at 432 nm LED. The color gamut area of a color-filtered RGB triangle of down-converted white LEDs (DC-WLEDs) incorporated with optimum SAMEu2+, Mn2+ green and K2SiF6Mn4+ (KSFMn4+) red phosphors is enlarged by 114% relative to that of the NTSC standard system in the CIE 1931 color space. The luminous efficacy of our DC-WLED was measured and found to be ∼92 lm/W at 20 mA. Increased energy transfers between dual activators and red-shifted band-edge and enhanced intensity of PLE spectrum indicate the possibility of developing dual-activated narrow-band green phosphors for wide-color gamut in an LCD backlighting system.Anacardic acid (AA), a compound extracted from cashew nut liquid, exhibits numerous pharmacological activities. The aim of the current investigation was to assess the anti-inflammatory, antinociceptive, and antioxidant activities of AA in mouse models. For this, Swiss albino mice were pretreated with AA (10, 25, 50 mg/kg, intraperitoneally, ip) 30 min prior to the administration of carrageenan, as well as 25 mg/kg of prostaglandin E2, dextran, histamine, and compound 48/80. The antinociceptive activity was evaluated by formalin, abdominal, and hot plate tests, using antagonist of opioid receptors (naloxene, 3 mg/kg, ip) to identify antinociceptive mechanisms. Results from this study revealed that AA at 25 mg/kg inhibits carrageenan-induced edema. In addition, AA at 25 mg/kg reduced edema and leukocyte and neutrophilic migration to the intraperitoneal cavity, diminished myeloperoxidase activity and malondialdehyde concentration, and increased the levels of reduced glutathione. In nociceptive tests, it also decreased licking, abdominal writhing, and latency to thermal stimulation, possibly via interaction with opioid receptors. Taken together, these results indicate that AA exhibits anti-inflammatory and antinociceptive actions and also reduces oxidative stress in acute experimental models, suggesting AA as a promising compound in the pharmaceutical arena.We demonstrated recently that CuPd/TiO2-Na bimetallic catalysts synthesized by sequential wet impregnation are active, selective, and stable for the hydrodeoxygenation (HDO) of glycerol into propylene glycol at low H2 pressure. The present study reports on the nature and distribution of Cu and Pd surface species in CuPd/TiO2-Na bimetallic catalysts using different scanning transmission electron microscopy techniques that supply cluster-specific alloying details. In particular, we used atomic-resolution Z-contrast imaging, X-ray energy-dispersive spectroscopy, and electron energy-loss spectroscopy. We also include X-ray photoelectron spectroscopy results. Our analysis shows that the metallic nanoparticles adopt mainly five different structures according to how the Cu and Pd atoms coordinate among themselves a homogeneous CuPd alloy structure (45-61%), a Cu shell/CuPd core (15-23%), a smaller number of particles formed by Cu on the surface and Pd in the nucleus (10-17%), and there are also nanoparticles formed only by Pd (4-7%) or by Cu (8-13%).